AZC-D55,AZC-Q55,AZC-Q2255,AZC-Q2155,AZC-N2255,密封开关
AZC-N2155,AZC-W55,AZC-W155,AZC-W255,AZC-W2155,AZC-W355,AZC-W3155
额定值 Rated number
额定电压 Rated voltage |
非电感性负载 Nonelectrical carry |
电感性负载(A) Electrical carry |
突入电流(A) Current |
|||||||
电阻性负载 Resistance oarry |
灯泡负载 Bulb carry |
电感性负载 Electrical carry |
马达负载 Motor carry |
|||||||
NC | NO | NC | NO | NC | NO | NC | NO | NC | NO | |
125VAC 250VAC |
10 10 |
3 2.5 |
1.5 1.25 |
10 10 |
5 3 |
2.5 1.5 |
30 MAX |
15 MAX |
||
8VDC 14VDC 30VDC 125VDC 250VDC |
10 10 6 0.5 0.25 |
3 3 3 0.4 0.2 |
1.5 1.5 1.5 0.4 0.2 |
6 6 5 0.05 0.03 |
5 5 5 0.05 0.03 |
2.5 2.5 2.5 0.05 0.03 |
操作速度 Operation speed |
0.05mm至0.5m/S(柱塞型) 0.05mm to 0.5m/Sec |
动作频率 Action frequency |
机械:120次/分 电气:20次/分 Mechanically:120 times/minute Electically:20 times/Minute |
接点电阻 Contact resistance |
15MΩ以下(初期) Under 15mΩ(initial) |
绝缘电阻 Insulation resistance |
100MΩ以上(500VDC) 100mΩ above (at 500VDC) |
耐电压 Bearing voltage |
非连续端子间1,000VAC,50/60Hz持续1分钟载电流与无载电流零件间与端子和接地之间2,000VAC,50/60Hz持续1分钟 Non-contact end:1,000VAC,50/60Hz for one minute Current parts and noncurrent parts and end and connect position :2,000VAC,50/60Hz for one minute |
振动 Vibration |
10至55HZ:1.5mm 10 to 55HZ:1.5mm |
冲击 Hitting |
机械耐久:1,000m/Sec2(约100G,S) 误动作耐久:100m/Sec2(约10G,S) Machine:1,000m/Sec2( Action:100m/Sec2( |
周围温度 Ambient temperature |
-10℃至 +80℃, -10℃ to +80℃ |
湿度 Humidity |
35%~95% RH , 35% to 95% RH |
使用寿命 Serve life |
机械:10,000,000次以上(在额定OT值下) 电气:500,000次以上 Mechanically:10,000,000 times above(at rated ot) Electrically:500,000 times above |
重量 Weight |
约92g(面板安装滚轮柱塞型) , |
防护等级 Protection structure |
IEC 规格:IP67 , IEC specification:IP67 |
型号Models | AZC-D55 | AZC-Q55 | AZC-Q2255 | AZC-Q2155 | AZC-N2255 | AZC-N2155 | AZC-W55 | AZC-W155 | AZC-W255 | AZC-W2155 | AZC-W355 | AZC-W3155 |
OF 最大(Max.) | 1200 | 1200 | 1200 | 1200 | 700 | 700 | 400 | 280 | 400 | 280 | 400 | 280 |
RF 最小(Min.) | 500 | 500 | 500 | 500 | 170 | 170 | 80 | 60 | 80 | 60 | 80 | 60 |
PT 最大(Max.) | 1.5mm | 1.5mm | 1.5mm | 1.5mm | 1.5mm | 1.5mm | - | - | - | - | - | - |
OT 最小(Min.) | 2.4mm | 3mm | 3mm | 3mm | 2.5mm | 2.5mm | 6mm | 8.4mm | 6mm | 8.4mm | 6mm | 8.4mm |
MD 最大(Max.) | 0.2mm | 0.2mm | 0.2mm | 0.2mm | 0.2mm | 0.2mm | 1mm | 1.4mm | 1mm | 1.4mm | 1mm | 1.4mm |
FP 最大(Max.) | - | - | - | - | - | - | 34.7mm | 36.7mm | 49.2mm | 51.3mm | 59.2mm | 61.2mm |
OP(mm) | 32.4±0.8mm | 38.2±0.8mm | 47.4±0.8mm | 47.4±0.8mm | 47.4±0.8mm | 47.4±0.8mm | 28.5±1.2mm | 28.5±1.2mm | 43±1.2mm | 43±1.2mm | 53±1.2mm | 53±1.2mm |