点击图片查看大图
AZX7100,AZX7110,AZX7310,AZX7311,AZX7312,AZX7120,小型限动开关
AZX7140,AZX7121,AZX7141,AZX7124,AZX7144,AZX7166
额定值 Rated number
| 额定电压 Rated voltage |
非电感性负载 Nonelectrical carry |
电感性负载(A) Electrical carry |
||||||
| 电阻性负载 Resistance oarry |
灯泡负载 Bulb carry |
电感性负载 Electrical carry |
马达负载 Motor carry |
|||||
| NC | NO | NC | NO | NC | NO | NC | NO | |
| 125VAC 250VAC 480VAC |
10 10 3 |
3 2.5 1.5 |
1.5 1.25 0.75 |
10 10 2.5 |
5 3 1.5 |
2.5 1.5 0.75 |
||
| 8VDC 14VDC 30VDC 125VDC 250VDC |
10 6 8 0.5 0.25 |
3 3 3 0.4 0.2 |
1.5 1.5 1.5 0.4 0.2 |
6 6 6 0.05 0.03 |
6 6 5 0.05 0.03 |
5 5 2.5 0.05 0.03 |
||
| 操作速度 Operation speed |
0.01mm至50cm/S(锁住塞型) , 0.01mm to 50cm/Sec |
| 动作频率 Action frequency |
120次/分 , 120 times/minute |
| 接点电阻 Contact resistance |
15MΩ以下(初期) , Under 15mΩ(initial) |
| 绝缘电阻 Insulation resistance |
100MΩ以上(在500VDC以下) , 100mΩ above (under 500VDC) |
| 耐电压 Bearing voltage |
非连续端子间1,000VAC,50/60Hz持续1分钟 载电流与无载电流零件间与端子和接地之间1,500VAC,50/60Hz持续1分钟 Non-contact end:1,000VAC,50/60Hz for one minute Current parts and noncurrent parts and end and connect position :1,500VAC,50/60Hz for one minute |
| 振动 Vibration |
误动作耐久：10至55Hz,1.5mm双振幅 Action:10 to 55Hz,1.5mm pairs swing |
| 冲击 Hitting |
机械耐久：1,000m/Sec2(约100G,S) 误动作耐久：300m/Sec2(约30G,S) Machine:1,000m/Sec2( Action:300m/Sec2( |
| 周围温度 Ambient temperature |
使用时:-10 至 +80℃ |
| 湿度 Humidity |
95%RH 以上 , 95% RH above |
| 使用寿命 Serve life |
机械:10,000,000次以上(在额定OT值下) 电气:500,000次以上 Mechanically:10,000,000 times above(at rated ot) Electrically:500,000 times above |
| 重量 Weight |
约60g , |
| 防护等级 Protection structure |
IEC 规格:IP65 ,IEC specification:IP65 |
| 型号Models | AZX7100 | AZX7110 | AZX7310 | AZX7311 | AZX7312 | AZX7120 | AZX7140 | AZX7121 | AZX7141 | AZX7124 | AZX7144 | AZX7166 |
| OF 最大(Max.) | 600g | 600g | 600g | 600g | 600g | 150g | 220g | 180g | 240g | 200g | 280g | 120g |
| RF 最小(Min.) | 100g | 100g | 100g | 100g | 100g | 40g | 60g | 50g | 80g | 60g | 100g | |
| PT 最大(Max.) | 2.0mm | 2.0mm | 2.0mm | 2.0mm | 2.0mm | 13.5mm | 8.5mm | 11mm | 6.5mm | 11mm | 6.5mm | 250mm |
| OT 最小(Min.) | 0.8mm | 5.0mm | 6.0mm | 6.0mm | 6.0mm | 4.0mm | 2.5mm | 3.0mm | 2.0mm | 3.0mm | 2.0mm | 11mm |
| MD 最大(Max.) | 0.8mm | 0.8mm | 0.8mm | 0.8mm | 0.8mm | 3.2mm | 2.0mm | 2.4mm | 1.5mm | 2.4mm | 1.5mm | |
| OP | 30.5±0.8mm | 44±1.2mm | 21.8±1.2mm | 33.3±1.2mm | 33.3±1.2mm | 25±1mm | 25±1mm | 40±1mm | 40±1mm | 50±1.2mm | 50±1.2mm | |
| FP | 35mm | 32mm | 46mm | 56mm |