VAT-H200-5,LED屏专用电源

MODEL

VAT-H200-5

OUTPUT

DC Output

5V

Rated Current

40A

Current Range     Note 1

0~40A

Ripple and Noise 

Note 2

0~65℃

200mV

Voltage ADJ.  Range

±10% of rated output voltage

Voltage Accuracy

±2.0%

Line Regulation

±0.5%

Load Regulation

±2.0%

Set-up Time

＜2.0S (220Vac input, Full load)

Hold up Time

＞10mS(220Vac input, Full load)

Temperature Coefficient

±0.03%/℃

Overshoot and Undershoot

<5.0%

INPUT

Voltage Range  

176Vac~264Vac

Frequency Range

47Hz~63Hz

Efficiency ( Typical)

81%(220Vac input)

AC Current (max.)

2.5A

Inrush Current (Typical)

45A@220Vac      Cold start

Leakage Current

Input—output:<0.25mA     Input—PG:<0.5mA

PROTECTION

Over Power

105%~150% of rated output power, auto recovery

Over Current

105%~150% of rated output current, auto recovery

Over Voltage

105%~150% of rated output voltage, auto recovery

Shorted Circuit

Long-term mode, auto recovery

ENVIRONMENT

Operating amb. Temp. & Hum.

-40℃~65℃;  20%~90%RH  No condensing

Storage Temp. & Hum.

-40℃~85℃;  10%~95%RH  No condensing

SAFETY &EMC

Note 3

Safety Standards

GB4943-2001; EN60950-1：2006

Withstand Voltage

Primary-Secondary:3.0KVac; ≤10mA .Primary-PG:1.5KVac; ≤10mA. Secondary-PG:0.5KVDC;≤10mA.

Isolation Resistance

≥100M ohms

EMI Conduction&Radiation

/

Harmonic Current

/

EMS Immunity

Compliance to EN61000-4-2,3,4,5,6,8,11;ENV50204,light industry level,criteriaA

OTHERS

MTBF (MIL-HDBK-217F)

More than 100,000Hrs (25℃, Full load)

Dimension  (L*W*H)

199×99×50mm

Packing

Cooling method

Cooling by free air convection

NOTE

1.     All parameters NOT specially mentioned are measured at rated input, rated load and 25℃ of ambient temperature.

2.     Measured at 20MHz of bandwidth by using a 12” twisted pair-wire terminated with a 0.1 uF & 10uF parallel capacitor.

3.  The SPS is considered a component which will be installed into final equipment. The equipment must be re-confirmed that it still meets EMC directives.